Cutting and skinning of pipes
Measure the pipe length and mark on the casing pipe.
Mark the cutting line with an adhesive tape around the pipe.
Cut the pipe with a customary handsaw with a saw blade for plastic along the cutting line.
Mark the skinning length of 22.5 cm from the pipe end on the casing pipe.
Cut the casing pipe with the pipe cutter up to the PUR-insulation layer around the whole pipe.
Slit the casing up to the PUR-insulation layer with a customary handsaw for plastic.
Detach the end of the casing pipe and then remove the PUR-insulation layer mechanically on the full skinning length.
Clean the skinned medium pipe and deburr the pipe ends inside and outside.