Heating-element socket welding with the welding machine – Part 1
Position and align the welding machine. Regard the required place!
Plug the machine and check, if the yellow operation lamp is on.
The welding depth of the required pipe dimension is adjusted by the turning button, which is at the left face side of the machine frame.
For pipe fixing push the back pair of clamping jaws at the front pair of clamping jaws and fix it by tightening of the fixing screws.
Hold the welding socket between the fitting clamping jaws and press it against the stops at the face side.
Fix the socket close to the stop und tighten the clamping jaws with the crank handle.
Push the pipe end between the clamping jaws and center it by turning the crank handle, but do not screw firmly.
For adjustment of the welding depth press the calibration button in the middle of the machine frame up to the stop