slide tuberias preaisladas

Processing with the winding machine

Insertion of the MONO TOP 40 corrosion protection tape.
Here, the corrosion protection tape MONO TOP 40 is pushed onto the central roll and the release film is laced onto the outer small roll in the designated slot.

Then the winding machine is adjusted.

The large adjusting screw in the center of the winding machine is used to adjust the tension compression. The small lower screw is used to adjust the winding radius.

The following setting calculation can be taken as a basis:

  1. Loosen the screw
  2. All 4 wheels must touch the base evenly
  3. Now the diameter of the KM-pipe is divided by 20, for example 160 mm KM-pipe / 20 = 8 mm
  4. The distance between base and one of the wheels should be about 8 mm.
  5. Now the screw is hand-tightened.